Cookie Consent by Free Privacy Policy Generator DMX shield til Arduino (færdigsamlet)
Udskriv produktside

DMX shield til Arduino (færdigsamlet)

Produktnr.: H42637

Privatkunder (slutanvändare) hänvisas till våra återförsäljare eller www.elextra.dk.
Logga in / Skapa konto för prisvisning och beställning.

Centrallager, Struer:
På fjärrlagring. Leverans 41-42 dagar.

Sampakgebyr: Kr. 20,- ekskl. moms.
Forsendelse (GLS erhverv): Kr. 48,- ekskl. moms.
Du måste ha ett användarkonto och vara inloggad för att använda den här funktionen. För att skapa konto Klicka här.
Klicka här för erbjudanden av min. stk.

This DMX / RDM Shield is a low cost high quality solution that allows you to connect your Arduino driven artwork into DMX512 networks. The shield is populated with high quality NEUTRIK XLR 3pin Connectors (1x male and 1x female). The MAX485 based shield can be used as DMX Master, Slave and as RDM transponder.

The following settings are configurable via the onboard jumpers:
- Send data via TX or Digital pin 4
- Receive data via RX or Digital pin 3
- Hardware slave mode or Software Controlled Slave/Master via Digital pin 2 (Required for RDM)
- Enable / Disable shield *
* In case you have the shield configured to use the RX and TX pins you have to disable the shield before you can upload your new sketch onto the Arduino board. This jumper allows you to disable the shield without disconnecting it from the Arduino board which saves time.

Software:

  • The Conceptinectics DMX Library for Arduino can be downloaded from sourceforge: http://sourceforge.net/projects/dmxlibraryforar
  • The library comes with few examples showing how to create a DMX Master or DMX Slave project...

Specifications:

  • XLR connections: 3-pin
Note: This is a "maker" module for developers. It is delivered without any further instructions than what you find here.

Volym rabatterade priser

Antal
>= 1
>= 2
>= 4

Egenskaper

Nedladdningar